For serious “brushers” out there, you will Want to make your own gadget. What about a Wisp quick draw gadget.
First you take a ball bearing drawer slide (some of them even have a locking mechanism. Cut it down to size with a hacksaw (one end) and carefully remove the ball bearings. Then shorten it some more by sawing the other end off. THen use a grinder to take off any shart edges or burrs. Next, put 2 dozen ball bearings back in place. The easiest way to do that is to grease up the holes on the ball bearing slide and then carefully apply each ball bearing.
You will need to drill a hole in the end and put in a set screw to stop the ball bearings out. THen drill another hole in the top end for another set screw to stop the slide coming off the whole assembly.
To secure it to your arm, pick up 2 identical belts and rivet them on. Now trim the ends and punch through a couple of holes. Secure the wisp using a small cable guide that has a sticky side.
No related posts.
Related posts brought to you by Yet Another Related Posts Plugin.